Differences

This shows you the differences between two versions of the page.

--- makerbot [2022/04/25 14:38] – Added warning about unattended. Added section on changing filament. swalde
+++ makerbot [2022/07/17 03:13] (current) – swalde
@@ Line 1: / Line 1: @@
 ====MakerBot Replicator 2====
-Link: to printer server [[http://octoprintserver.int.sktw.ca:5000]], this link only works at Techworks.
+Link: to printer server [[http://octoprintserver.int.sktw.ca:5000]], this link only works at Techworks. (Link currently does NOT work. Use the SD card method below.)
 This printer is a classic in the shop. Its a 2012 printer with a print volume 285x153x155mm.  It is configured to print with PLA only.

makerbot.txt · Last modified: 2022/07/17 03:13 by swalde

Back to top