Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
inventory [2019/12/29 22:11] – swalde | inventory [2022/04/14 03:48] – braeden.leislar | ||
---|---|---|---|
Line 1: | Line 1: | ||
3D Printers: | 3D Printers: | ||
- | * Solidoodle 3 with 20cm x 20cm x 20cm print area and heated bed, configured for ABS. | + | * [[Makerbot|MakerBot Replicator 2]] |
- | * MakerBot Replicator 2 with 28cm x 15cm x 15cm print area, configured | + | * [[Resin Printer|Anycubic Photon S (SLA Resin Printer)]] |
+ | * <del>Solidoodle 3 with 20cm x 20cm x 20cm print area and heated bed, configured for ABS. (down for rebuild)</ | ||
Laser Cutter: | Laser Cutter: | ||
- | * Ruida controller with 1300mm x 1000mm | + | * Ruida controller with 1300mm x 1020mm |
Electronics bench: | Electronics bench: | ||
Line 47: | Line 48: | ||
* dremel tools | * dremel tools | ||
* miter saw | * miter saw | ||
- | * table saw (Upgraded December | + | * table saw (Upgraded December |
* skilsaw | * skilsaw | ||
* more hand tools | * more hand tools |