Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
cnc_machine_goliath [2018/03/15 19:21] swaldecnc_machine_goliath [2022/07/17 03:23] (current) swalde
Line 1: Line 1:
 +=== Note: Goliath is no longer at the space.  The Laguna is a more capable replacement ===
 +[[laguna|Laguna]]
 +
 === CNC Training === === CNC Training ===
  
Line 8: Line 11:
   * Hair tied back and out of the way   * Hair tied back and out of the way
   * If you notice anything strange with the machine DO NOT USE IT   * If you notice anything strange with the machine DO NOT USE IT
-    * Notify Albert+    * Notify thespace@sktechworks.ca
   * Be aware of where the big red button is   * Be aware of where the big red button is
     * Pushing the button will stop the current job from processing      * Pushing the button will stop the current job from processing 
Line 14: Line 17:
     * turn off the switch for that     * turn off the switch for that
     * turn off the switch for cnc power     * turn off the switch for cnc power
-    * notify Albert+    * notify thespace@sktechworks.ca
   * Be aware of all the different ways you can shut off the machine   * Be aware of all the different ways you can shut off the machine
     * Safety should be your number one concern     * Safety should be your number one concern
Line 158: Line 161:
  
 ==Fusion 360 Toolpaths== ==Fusion 360 Toolpaths==
 +I nice formatted tutorial of how to setup a job in Fusion 360
 +[[http://evanandkatelyn.com/2018/01/fusion-360-cam-tutorial-for-cnc-beginners/]]
 +
 +{{:Techworks.zip| Fusion 360 Post Processor}}
 +
 Update: the following G28 thing might actually not be necessary.  Before setting the origin on the workpiece, move the spindle to a safe location above the workpiece.  Then, click "Ref All Home."  If you do this, that location will be the "Home" position that G28 goes to. Update: the following G28 thing might actually not be necessary.  Before setting the origin on the workpiece, move the spindle to a safe location above the workpiece.  Then, click "Ref All Home."  If you do this, that location will be the "Home" position that G28 goes to.
  
cnc_machine_goliath.1521141686.txt.gz · Last modified: 2018/03/15 19:21 by swalde
Back to top
Driven by DokuWiki Recent changes RSS feed Valid CSS Valid XHTML 1.0