Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
cnc_machine_goliath [2018/03/15 17:15] – swalde | cnc_machine_goliath [2022/07/17 03:23] (current) – swalde | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | === Note: Goliath is no longer at the space. | ||
+ | [[laguna|Laguna]] | ||
+ | |||
=== CNC Training === | === CNC Training === | ||
Line 8: | Line 11: | ||
* Hair tied back and out of the way | * Hair tied back and out of the way | ||
* If you notice anything strange with the machine DO NOT USE IT | * If you notice anything strange with the machine DO NOT USE IT | ||
- | * Notify | + | * Notify |
* Be aware of where the big red button is | * Be aware of where the big red button is | ||
* Pushing the button will stop the current job from processing | * Pushing the button will stop the current job from processing | ||
Line 14: | Line 17: | ||
* turn off the switch for that | * turn off the switch for that | ||
* turn off the switch for cnc power | * turn off the switch for cnc power | ||
- | * notify | + | * notify |
* Be aware of all the different ways you can shut off the machine | * Be aware of all the different ways you can shut off the machine | ||
* Safety should be your number one concern | * Safety should be your number one concern | ||
Line 158: | Line 161: | ||
==Fusion 360 Toolpaths== | ==Fusion 360 Toolpaths== | ||
+ | I nice formatted tutorial of how to setup a job in Fusion 360 | ||
+ | [[http:// | ||
+ | |||
+ | {{: | ||
+ | |||
+ | Update: the following G28 thing might actually not be necessary. | ||
+ | |||
This is very, very preliminary, | This is very, very preliminary, | ||
DISABLE G28. If you leave G28 enabled, the machine will rapid to a bad place. | DISABLE G28. If you leave G28 enabled, the machine will rapid to a bad place. |