Mounted fire extinguisher in hall way up stairs
Printed off logo for Nathan and placed it up stairs - by the lights that he is sponsoring the community green screen space with.
Built movable tailstock, as part of rotary attachment, and submitted a web site write up.
Created wiring harness for Goliath to use rotary attachment
Will need training to use
Issues with rapid Zs - need new profile for when using the rotary
Open s cad script for calculating steps per inch hack for any circumference
Z rapid and safe z setting in aspire, don't know how to change the go to zero button height in mock 3
Brought a metal trolley for the welder , its easy to roll outside and its metal so it wont start on fire like the table
Brought welding stuff, angle magnets, hammer, ground magnet, extra wire
Found lathe with stripped t bolts….. reminder when you break the lathe if you not sure how to fix it leave a sticky note.. the lathe can often fix its self.
Made new t-bolts for the lathe and made an extra set.
Made a power cross feed drill attachment for the lathe
Made tiny drill bit tool for lathe
Vice maintenance:
Lathed a collar so that the handle no longer jams against the body of the vice
Straightened out a bent pin ( rotation movement clamp)
Tightened mounting bolts
Tightened bolt loading acme nut ( now the vise isn't sloppy and loose)
Greased all the ways and the acme thread
Made a power feed attachment so you can move the vise with a drill
Helped the land lord Jeff with the neighbors door, and talked to him about the kiln - he said as long as its to code and we pay for the electrical work we can do it
Forge - landlord said yes as long as its only out side we can do it ( then Jeff told me about how he has cast a brass fish he caught)
Welding table out side - Jeff said Yes to this and offered to bring his metal welding table. He did bring it its out side and need legs
Offered to install window that land lord brought
Brought a new tool wind up spring maker
Jared notified me that the table saw fence was loose
Upon investigation i found that it was bent and missing a bolt
Bought a new bolt kit, replaced bolt
Strengthen out bent part of fence .. now the fence is good
Jared notified that the miter saw was not cutting 90 when set to 90 adjusted it and now its cutting square. Note Miter saw is very dull
Made up a computer fan and pipe to blow warm air on frozen pipes in kim space ( freeing up our vacuum )
Found the drill press vise acme thread to be bent… me an bob straightened it and cleaned up the ways and added a missing bolt to the vise works good again
Printed off sign up papers for workshops list and suggested courses