Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
laser_cutter [2019/09/09 19:38] swalde |
laser_cutter [2019/11/29 22:17] (current) swalde |
||
---|---|---|---|
Line 1: | Line 1: | ||
==== Laser Cutter ==== | ==== Laser Cutter ==== | ||
+ | |||
+ | ==== Getting Started Manual ==== | ||
+ | [[https://sktechworks.ca/wp-content/uploads/2019/11/FrankenLaser-1.pdf|Quick Reference Guide]] | ||
==== Inkscape ==== | ==== Inkscape ==== | ||
Line 17: | Line 20: | ||
| PET-G | .020" | 100% | 75mm/s | | | | PET-G | .020" | 100% | 75mm/s | | | ||
| Acrylic | 1/8" - 3mm | 100% | 20mm/s | | | | Acrylic | 1/8" - 3mm | 100% | 20mm/s | | | ||
- | | ABS | 1/8" - 3mm | 100% | 11mm/s | *** Tested on new tube *** Used to say 18, but that wouldn't cut through. | | + | | ABS | 1/8" - 3mm | 100% | 11mm/s | *** Tested on new tube *** Used to say 18, but that wouldn't cut through. Third tube is running better, now. Maybe back to 18?| |
| Felt | 1/16" | 10% | 20mm/s | Use backing board | | | Felt | 1/16" | 10% | 20mm/s | Use backing board | | ||
| Styrene | 0.30" | 100% | 20mm/s | | | | Styrene | 0.30" | 100% | 20mm/s | | |