Trace:
You are here: start » laser_cutter

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
laser_cutter [2019/11/30 03:15] – swaldelaser_cutter [2019/11/30 03:17] – swalde
Line 20: Line 20:
 | PET-G | .020"       | 100%   | 75mm/s   | | | PET-G | .020"       | 100%   | 75mm/s   | |
 | Acrylic | 1/8" - 3mm | 100% | 20mm/s  | | | Acrylic | 1/8" - 3mm | 100% | 20mm/s  | |
-| ABS | 1/8" - 3mm | 100% | 11mm/s  | *** Tested on new tube *** Used to say 18, but that wouldn't cut through. |+| ABS | 1/8" - 3mm | 100% | 11mm/s  | *** Tested on new tube *** Used to say 18, but that wouldn't cut through. Third tube is running better, now.  Maybe back to 18?|
 | Felt | 1/16" | 10% | 20mm/s  | Use backing board | | Felt | 1/16" | 10% | 20mm/s  | Use backing board |
 | Styrene | 0.30" | 100% | 20mm/s  |  | | Styrene | 0.30" | 100% | 20mm/s  |  |
laser_cutter.txt · Last modified: 2021/07/10 04:21 by reveng
Back to top
Driven by DokuWiki Recent changes RSS feed Valid CSS Valid XHTML 1.0