Differences

This shows you the differences between two versions of the page.

--- laser_cutter [2019/09/09 23:38] – swalde
+++ laser_cutter [2019/11/30 03:17] – swalde
@@ Line 1: / Line 1: @@
 ==== Laser Cutter ====
+==== Getting Started Manual ====
+[[https://sktechworks.ca/wp-content/uploads/2019/11/FrankenLaser-1.pdf|Quick Reference Guide]]
 ==== Inkscape ====
@@ Line 17: / Line 20: @@
 | PET-G | .020"       | 100%   | 75mm/s   | |
 | Acrylic | 1/8" - 3mm | 100% | 20mm/s  | |
-| ABS | 1/8" - 3mm | 100% | 11mm/s  | *** Tested on new tube *** Used to say 18, but that wouldn't cut through. |
+| ABS | 1/8" - 3mm | 100% | 11mm/s  | *** Tested on new tube *** Used to say 18, but that wouldn't cut through. Third tube is running better, now.  Maybe back to 18?|
 | Felt | 1/16" | 10% | 20mm/s  | Use backing board |
 | Styrene | 0.30" | 100% | 20mm/s  |  |

laser_cutter.txt · Last modified: 2021/07/10 04:21 by reveng

Back to top