Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
laser_cutter [2019/09/09 23:37] swaldelaser_cutter [2019/09/09 23:38] swalde
Line 17: Line 17:
 | PET-G | .020"       | 100%   | 75mm/  | | | PET-G | .020"       | 100%   | 75mm/  | |
 | Acrylic | 1/8" - 3mm | 100% | 20mm/ | | | Acrylic | 1/8" - 3mm | 100% | 20mm/ | |
-| ABS | 1/8" - 3mm | 100% | 11mm/ | *** Tested on new tube *** |+| ABS | 1/8" - 3mm | 100% | 11mm/ | *** Tested on new tube *** Used to say 18, but that wouldn't cut through. |
 | Felt | 1/16" | 10% | 20mm/ | Use backing board | | Felt | 1/16" | 10% | 20mm/ | Use backing board |
 | Styrene | 0.30" | 100% | 20mm/ |  | | Styrene | 0.30" | 100% | 20mm/ |  |
laser_cutter.txt · Last modified: 2021/07/10 04:21 by reveng
Back to top
Driven by DokuWiki Recent changes RSS feed Valid CSS Valid XHTML 1.0