Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
cnc_machine_goliath [2018/03/15 17:15] swaldecnc_machine_goliath [2022/07/17 03:23] (current) swalde
Line 1: Line 1:
 +=== Note: Goliath is no longer at the space.  The Laguna is a more capable replacement ===
 +[[laguna|Laguna]]
 +
 === CNC Training === === CNC Training ===
  
Line 8: Line 11:
   * Hair tied back and out of the way   * Hair tied back and out of the way
   * If you notice anything strange with the machine DO NOT USE IT   * If you notice anything strange with the machine DO NOT USE IT
-    * Notify Albert+    * Notify thespace@sktechworks.ca
   * Be aware of where the big red button is   * Be aware of where the big red button is
     * Pushing the button will stop the current job from processing      * Pushing the button will stop the current job from processing 
Line 14: Line 17:
     * turn off the switch for that     * turn off the switch for that
     * turn off the switch for cnc power     * turn off the switch for cnc power
-    * notify Albert+    * notify thespace@sktechworks.ca
   * Be aware of all the different ways you can shut off the machine   * Be aware of all the different ways you can shut off the machine
     * Safety should be your number one concern     * Safety should be your number one concern
Line 158: Line 161:
  
 ==Fusion 360 Toolpaths== ==Fusion 360 Toolpaths==
 +I nice formatted tutorial of how to setup a job in Fusion 360
 +[[http://evanandkatelyn.com/2018/01/fusion-360-cam-tutorial-for-cnc-beginners/]]
 +
 +{{:Techworks.zip| Fusion 360 Post Processor}}
 +
 +Update: the following G28 thing might actually not be necessary.  Before setting the origin on the workpiece, move the spindle to a safe location above the workpiece.  Then, click "Ref All Home."  If you do this, that location will be the "Home" position that G28 goes to.
 +
 This is very, very preliminary, but critical: This is very, very preliminary, but critical:
 DISABLE G28.  If you leave G28 enabled, the machine will rapid to a bad place.  If you are lucky, it will only break your bit.  If you are not lucky, you will break the machine.  This has already happened once. DISABLE G28.  If you leave G28 enabled, the machine will rapid to a bad place.  If you are lucky, it will only break your bit.  If you are not lucky, you will break the machine.  This has already happened once.
cnc_machine_goliath.1521134119.txt.gz · Last modified: 2018/03/15 17:15 by swalde
Back to top
Driven by DokuWiki Recent changes RSS feed Valid CSS Valid XHTML 1.0